Electrolux Washer Error Code F 01

F 01 indicates an internal fault within the washer's main control board. The board has detected a problem with its own circuitry and halted normal operation as a result. This code can appear after a power event or due to component failure on the board itself. If a simple reset does not clear it, the control board will need to be replaced.

Pressing the Stop/Clear pad is the recommended first step and may clear the code if the fault was caused by a temporary power glitch. If the F 01 code returns when the washer is restarted, the reset has not resolved the underlying problem and the control board itself has a confirmed internal failure that requires replacement.

If the control board needs to be replaced, the total repair cost including parts and labor typically falls in the range of $150 to $400 depending on your location and the specific model. The control board part itself varies in price, and labor costs depend on the technician's rates. If the code clears with a simple reset and does not return, there is no cost at all.

You can attempt the first diagnostic step yourself by pressing the Stop/Clear pad to reset the control. If the code clears and does not return, no further action is needed. However, if the code persists or comes back when the washer is restarted, the control board requires replacement, which involves disconnecting and reconnecting wiring harnesses and is best handled by a technician comfortable working inside the machine.

No, you should not attempt to run a wash cycle while the F 01 code is active. The control board has flagged an internal fault and the machine will not operate normally. Continuing to force the washer through cycles could cause incomplete wash or drain sequences, and a damaged control board should be addressed before resuming regular use.