Fisher & Paykel Washer Error Code 00000001

00000001Fisher & Paykel Washer

What this code means

Phase 1 - Display Module Fault; Phase 2 to 6 - Motor Control Module Fault. The Motor Control Module (Display Module for Phase 1) has encountered an error when writing to an EEPROM address.. Possible causes: Motor Control Module failure; Display Module failure (Phase 1)

Next steps: diagnose the root cause

1
Verify the error code is active

Power cycle the unit and see if the code returns. If it does, the fault is persistent and requires diagnosis.

2
Get the full diagnostic procedure

Get step-by-step guidance, test values, and wiring diagrams from the OEM service manual.

Start diagnosing 00000001 on your Fisher & Paykel washer

$29/month · Cancel anytime · Or $9.95 3-day pass

What’s available for Fisher & Paykel washer models

Access Fisher & Paykel washer service manuals, wiring schematics, exploded parts views, and error code references on MyPros+.

Related Fisher & Paykel washer error codes

00000011Phase 1 to 6 Motor Controller Module Fault. The Motor Controller Module has...00001000Size Switch Error - display size setting does not match stored memory. Possible...00001001Size Switch Error - Display size setting does not match that which is stored in...00001100Flood Protection Error. Possible causes: Water overflow detection; Flood sensor...12Flood Function Error3Motor Control Module Fault - General memory error9Size Switch ErrorE7:00Wash motor error. Possible causes: Motor malfunction; Motor control issue
STOP GUESSING·Start verifying

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get Started