Frigidaire Dryer Error Code E00

E00 on a Frigidaire dryer means the control board has no stored fault codes in its memory. It is not an error condition but rather a status indicator confirming a clean fault history. This code typically appears when a technician retrieves fault data and the system has recorded no failures.

Yes, E00 does not indicate a safety hazard or an active component failure. The dryer is safe to operate when this code is present. If you have concerns about dryer performance alongside this code, investigate the behavior directly rather than relying on the fault history.

Since E00 is not a fault code, there is typically no repair cost associated with it directly. If a technician visits to diagnose a dryer that shows E00 alongside a performance complaint, expect a standard diagnostic service fee in the range of $75 to $150 depending on your region. Any additional repair costs would depend on what the active diagnostic process uncovers.

If the dryer is running normally and E00 appears during a diagnostic check, no repair is needed. E00 simply means no faults have been logged. However, if the dryer is not performing correctly despite showing E00, you should run an active diagnostic cycle to look for issues that have not yet been captured as a stored code.

E00 is not a fault code that needs to be cleared. It already reflects an empty or clean fault log. Performing a reset will not change this status and is not necessary when E00 is the only code present.