Frigidaire Washer Error Code dr

The dr code stands for door open, meaning the washer's control board is not receiving a signal that the door is fully latched. The washer will not operate until the door is confirmed closed. It can indicate a door that was not pushed shut completely, or a fault in the door latch assembly or its wiring.

Resetting the washer, typically by unplugging it for one to two minutes and plugging it back in, may clear the code temporarily if it was triggered by a minor glitch. However, if the underlying cause is a faulty latch, a misaligned door, or a wiring problem, the dr code will return as soon as you attempt to start a new cycle. Fixing the root cause is necessary for a permanent resolution.

If the fix is simply closing the door properly or reseating a loose wiring connector, there is no parts cost involved. If the door latch assembly needs replacement, parts typically range from $20 to $60 depending on the model, with professional labor adding $75 to $150 or more. Diagnosing the exact failed component before ordering parts helps avoid unnecessary expense.

Start by pressing the door firmly closed until you hear a click, then try restarting the cycle. If the code returns, inspect the door latch and strike for visible damage or misalignment. If the latch looks intact, check the wiring connector at the latch assembly for looseness or corrosion. A latch assembly that is mechanically or electrically failed will need to be replaced.

The washer is designed to prevent operation when the dr code is active, so it will not spin or agitate with an unsecured door. You should not attempt to override or bypass the door lock system. Resolve the cause of the code before using the machine to avoid water leaks or injury from a door that opens during a cycle.