Frigidaire Washer Error Code Err

Err on a Frigidaire washer means the cycle selector knob was turned to a different position after a cycle had already been started. The control board locks in the selected cycle when Start is pressed, and turning the knob afterward creates an input conflict that triggers this alert. It is not an indication of a mechanical failure. Pressing Cancel, reselecting the cycle, and pressing Start will clear it.

Using the Cancel button functions as the appropriate reset for this alert and will clear the Err display. If the Cancel button does not respond, unplugging the washer for one to two minutes and then plugging it back in can also reset the control board. After power is restored, select your cycle and press Start normally.

In most cases there is no repair cost at all, since the Err code is caused by turning the cycle selector knob during an active cycle, which is resolved by using the Cancel and Start buttons correctly. If the code appears repeatedly without any knob movement, a faulty cycle selector switch may be the cause. Replacement parts and labor for a selector switch typically range from around $50 to $150 depending on the specific model and service rates in your area.

Press the Cancel button to stop the active cycle and allow the washer to drain. Once the cycle is fully cancelled, rotate the selector knob to the cycle you want, and press Start to begin a fresh cycle. Do not simply turn the knob without pressing Cancel first, as that is what causes the Err code to appear.

No, the Err code does not indicate a safety hazard. It is a control input alert that prevents the machine from executing conflicting commands. The washer stops and waits for correct input rather than continuing in an undefined state. No risk to the appliance, the laundry, or the user is associated with this code.