GE Dryer Error Code LCD Display Touchscreen

This error means the control board detected a continuous touch input on the LCD display panel lasting longer than 30 seconds. It can be caused by a physical obstruction on the screen, moisture on the panel surface, a wiring connection issue, or a defective touchscreen component. The dryer will continue to operate normally while this error is active.

This error is not a safety shutdown fault. GE dryers will continue to operate normally when this error is present, so it does not pose an immediate safety risk. However, it should be investigated and resolved to ensure the control panel is functioning correctly and not sending unintended commands to the dryer.

If the fix is as simple as removing an obstruction or cleaning the panel, there is no parts cost involved. Wiring repairs or connector replacements are generally low cost, typically in the range of $20 to $75 for parts and labor if a technician is needed. Replacing a defective touchscreen assembly or control board can range from $100 to $350 or more depending on the specific model and whether professional installation is required.

Start by checking for anything pressing against the control panel surface and remove it if found. Next, clean the touchscreen with a dry cloth to eliminate any moisture or residue. Then inspect the wiring harness connections at the display and control board for loose or corroded contacts. If those steps do not resolve the issue, the touchscreen assembly or control board may need to be replaced.

A reset may temporarily clear the error display, but the fault will likely return if the underlying cause is not addressed. If an obstruction or moisture was responsible, removing it before resetting should prevent the error from returning. If a wiring fault or hardware failure is the cause, a reset alone will not provide a lasting fix.