GE Freezer Error Codes

7 error codes for GE freezer models. Each links to the full diagnostic procedure from the service manual.

CodeDescription

E2 OPFreezer (FZ) sensor is out of range and/or open circuit.E2 SHFreezer (FZ) sensor is out of range and/or shorted.E5 OPDefrost sensor is out of range and/or open circuit.E5 SHDefrost sensor is out of range and/or shorted.E7 OPAmbient temperature sensor is out of range and/or open circuit.E7 SHAmbient temperature sensor is out of range and/or shorted.F3Air sensor defective.

MyPros+ Max

Get the full diagnostic procedure for any GE freezer error code.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts
Verified part numbers when replacement is required

Get started

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·GE Freezer

E2 OP on my GE Freezer

M+

Freezer (FZ) sensor is out of range and/or open

From Service Manual 114411, p.23:

1.Check freezer thermistor resistance against the Thermistor Temperature Ohm Chart; replace if out of range.

2.Disconnect the sensor and measure resistance at the sensor body. Expected: 10 kΩ to 12 kΩ at 77°F (25°C).

3.Check the sensor harness for opens and shorts. Back-probe the sensor pins at the control board connector; a reading outside 5 kΩ to 50 kΩ indicates a failed sensor.

Part WR55X10025

Temperature sensor

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get started