GE Refrigerator Error Code 0600

The 0600 code on a GE refrigerator indicates an FF IM fault, referring to the French door freezer ice maker system. It signals that the control board has detected a problem with the ice maker or its communication circuit. GE notes this code is not applicable for all models, so it may not represent an active fault on every unit that displays it.

A reset may temporarily clear the code, but if an underlying fault exists, the code will likely return after the control board runs its diagnostic cycle again. Resetting the unit by unplugging it for a few minutes is worth trying, but a persistent 0600 code should be investigated to rule out a wiring or component failure.

Repair costs vary depending on the cause. If only a wiring harness or connector needs attention, costs may be minimal, typically in the range of $50 to $150 for a service call. Replacing an ice maker assembly generally runs between $100 and $300 in parts and labor, while a main control board replacement can range from $200 to $500 or more depending on the model and labor rates in your area.

In some cases, yes. If the code is not applicable to your model, no repair may be needed. For applicable models, checking and reseating the wiring harness connections at the ice maker and control board is a reasonable first step a knowledgeable DIYer can perform. Replacing the ice maker assembly or control board is more involved and may benefit from professional service.

In most cases, the 0600 fault is isolated to the ice maker circuit and does not affect the core cooling functions of the refrigerator or freezer. Your food should remain safely stored. However, the ice maker may not produce ice while the fault is active, and the underlying cause should be addressed to prevent any further issues.