GE Washer Error Code 2
Lid Monitor - Control did not get lid closed signal from switch while motor was moving. Could mean the switch didn't close or control didn't get the signal because of lack of connection.
SourceGE Washer - Service Manual: Binary Display Fault Chart (GTW680BSJ1WA)
The full 2 procedure
Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.
SourceGE Washer - Service Manual: Binary Display Fault Chart (GTW680BSJ1WA)
Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.
Where this code is documented
18 manuals in the MyPros+ library document this code for GE washer.
Models covered by the manuals that document this code
- 210
- 290D2158G005
- 31-16928
- 410
- 460
- 490
- 5TW4307SW0WS
- 600
- 680
- ETW485ASW0WB
- GFW400
- GFW400SCM
- GFW430SSM
- GFW450
- GFW450SPM
- GFW450SSM
- GFW480SPK
- GFW480SPK0
- GFW480SSK
- GFW480SSK0
- GFW490RPK
- GFW490RPK0
- GFW490RSK
- GFW490RSK0
More models are covered than are listed here.
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax