GE Washer Error Code Control Board Failure (Min Water Level)

This error means the washer's control board attempted to begin agitating clothes before the tub contained the minimum required amount of water. The control board is supposed to prevent this from happening by monitoring the water level pressure switch. When the board proceeds with agitation anyway, it indicates the board itself has failed and can no longer enforce this safety condition.

No, it is not safe to continue running the washer with this fault active. The control board has already demonstrated that it will initiate agitation without adequate water in the tub, which can cause the agitator and motor to operate dry. This risks accelerated wear and potential damage to the transmission and drive components. The washer should remain out of service until the control board has been replaced.

A power reset, such as unplugging the washer for a few minutes and plugging it back in, may temporarily clear the error display. However, because this fault is caused by a hardware failure within the control board itself, the error will return as soon as the washer attempts to run a cycle. A reset does not repair the underlying board failure and should not be relied on as a solution.

Replacing a control board is within reach for a skilled DIYer who is comfortable working with appliance wiring and following proper safety precautions, including unplugging the washer before beginning any work. However, the diagnosis should be confirmed before purchasing parts, since control boards are not inexpensive. If you are unsure about handling internal wiring or identifying the correct board, a licensed appliance technician can complete the replacement.

The cost of a replacement control board for a GE washer typically falls in the range of $150 to $350 for the part alone, depending on the specific model. If you hire a technician to perform the replacement, expect total repair costs including labor to range from $250 to $500 or more. Obtaining the correct board for your specific model number before ordering is important, as boards are model-specific.