GE Washer Error Code E4E

E4E means the washer detected an under-voltage condition on the DC bus immediately after a start attempt, and the motor did not run as a result. The inverter board, which controls motor speed and power, did not receive the minimum required voltage at startup. The fault covers tumble and spin cycle startup conditions. If a 30-second power reset does not clear it, the inverter board typically needs to be replaced.

No, you should not continue running the washer while E4E is active. The error means the motor did not start due to insufficient voltage, and forcing repeated start attempts can stress the inverter and motor components further. Address the fault before using the machine again to avoid potential additional damage.

A reset by unplugging the washer for 30 seconds is the first recommended step and will clear E4E if the cause was a transient voltage sag. However, if the inverter board is failing or there is an ongoing power supply problem, the code will return the next time the washer attempts to start. A reset that does not hold is a strong indicator that the inverter board needs to be replaced.

Yes, in some cases. Start by unplugging the washer, waiting 30 seconds for the capacitors to discharge, then plugging it back in and running a cycle. If the error was caused by a temporary power fluctuation, this reset will often clear it. If the error returns consistently, further diagnosis of the inverter board and power supply connections is needed, and part replacement may be required.

If the fix is simply a power reset, there is no cost. If the inverter board needs to be replaced, parts typically range from $80 to $200 depending on the specific model, and professional labor can add $100 to $200 on top of that. Diagnosing and correcting a wiring or connection issue is generally less expensive than a full inverter replacement.