GE Washer Error Code NO PUMP

The NO PUMP error means the washer detected that it was pumping air while the water level pressure switch was still registering water in the tub. This indicates a problem in the drain system: the machine ran the drain pump but could not confirm that water was successfully removed. The fault points to a blocked or failed pump, a restricted drain hose, or a faulty pressure switch.

You should not continue using the washer while this error is active. If the machine cannot drain, water will remain in the tub and laundry will be left soaking wet. Repeated attempts to run cycles without resolving the fault can also strain the pump motor further and potentially lead to more expensive repairs.

If the pump simply has a blockage that can be cleared without parts, the repair cost is minimal, covering only your time or a basic service call fee ranging from around $50 to $100. If the drain pump motor needs replacement, parts and labor typically range from $150 to $350 depending on your model and local labor rates. A faulty pressure switch is generally a less expensive repair, with parts usually in the $20 to $60 range.

In many cases, yes. Start by checking the drain pump for obstructions such as coins or debris caught in the impeller, as this is the most common cause and requires no parts. Also inspect the drain hose for kinks or blockages. If the pump impeller spins freely but the pump still does not move water, or if you find no obvious obstruction, the pump motor or pressure switch may need to be replaced, which requires ordering the correct parts for your model.

A reset may temporarily clear the error code from the display, but if the underlying cause such as a clogged pump or faulty pressure switch is not corrected, the error will return as soon as the washer attempts another drain cycle. Resetting should only be used after the root cause has been identified and repaired.