Maytag Dishwasher Error Code F2-E1

F2-E1 means the control board has detected a stuck key in the keypad or a problem with the keypad connection. The control sees a button signal that does not release, which triggers this fault. It can be caused by a damaged keypad membrane, moisture intrusion, or a faulty connection between the keypad and the control board.

It is not recommended. A stuck key condition can cause the control board to behave unpredictably, and the dishwasher may not start or stop cycles as expected. Disconnect power until the fault is diagnosed and repaired to avoid unintended operation.

Costs vary depending on the failed component. A replacement keypad or touchpad typically runs in the range of $30 to $120 for the part alone. If the control board is at fault, parts costs are generally higher, often in the $100 to $250 range. Adding professional labor will increase the total, usually bringing a full repair to somewhere between $150 and $400 depending on your location and the specific parts needed.

In some cases, yes. Start by checking each button for responsiveness and look for any that feel stuck or do not spring back. If the connector between the keypad and control board is loose, reseating it may clear the error. If the keypad membrane is damaged or moisture-affected, replacing the keypad is a repair many experienced DIYers can handle after unplugging the dishwasher and disassembling the door panel.

A reset may temporarily clear the code, but if the underlying cause, such as a damaged keypad or poor connection, is still present, the error will return. A reset is useful for ruling out a one-time communication glitch, but a recurring F2-E1 requires hands-on diagnosis of the keypad and its wiring.