Maytag Dishwasher Error Code F5-E2

F5-E2 means the control board detected that the door switch did not open between cycles, suggesting the switch may be stuck in the closed position. The control uses this check as a safety measure and will not allow a new cycle to start until it sees the switch transition properly. The fault involves the door latch assembly and its associated switch contacts.

A reset may temporarily clear the code, but if the door switch or latch assembly has a mechanical or electrical fault, the code will return. The most effective first step is opening and closing the door and pressing Start/Resume rather than a full power reset. A lasting fix requires addressing the underlying switch or latch problem.

If only the door switch or latch assembly needs replacement, parts typically range from around $20 to $80 depending on the specific components involved. If professional labor is needed, total repair costs generally fall in the range of $100 to $250. In cases where the control board is at fault, costs can be higher.

Start by opening the door completely, closing it firmly until the latch clicks, and then pressing the Start/Resume key. If the dishwasher runs normally after that, make sure to open the door between cycles going forward. If the code returns, the door latch assembly and switch contacts should be inspected and the switch resistance measured to determine whether the switch or latch needs replacement.

The dishwasher is designed to prevent a new cycle from starting when this code is active, so it will not operate in a potentially unsafe state. However, you should not attempt to force or bypass the door latch to get the machine running. Addressing the latch or switch issue properly is the correct path before resuming normal use.