Maytag Dishwasher Error Code F6-E1

F6-E1 indicates a low or no water condition caused by a mechanical problem. The dishwasher is not receiving enough water during the fill cycle, or water is escaping the tub before the fill sensor is satisfied. Causes range from a closed supply valve and plugged inlet screen to a detached drain loop, a stuck overfill switch, or a failed fill valve.

The dishwasher will not complete a wash cycle while this fault is active, so continuing to run it will produce no useful results. If the code is caused by a water leak, running the unit repeatedly could allow water to accumulate under the appliance and cause floor or cabinet damage. Diagnose and resolve the fault before attempting further cycles.

Repair costs vary depending on the cause. Cleaning a plugged inlet screen or repositioning a drain hose costs nothing beyond your time. Replacing a faulty fill valve typically runs between $40 and $100 for the part, plus labor if a technician is involved. An overfill float switch is generally less expensive, usually in the $15 to $40 range for the part. Professional diagnostic and repair visits commonly range from $100 to $250 total depending on your location and the parts needed.

Start by confirming the water shutoff valve under the sink is fully open and the supply line is not kinked. Next, check that the drain hose is properly looped or connected to an air gap to prevent siphoning. Inspect the fill valve inlet screen for mineral buildup and clean it if blocked. If those steps do not resolve the fault, test or replace the overfill float switch and the fill valve itself.

A reset may temporarily clear the code from the display, but the fault will return as soon as the dishwasher attempts another fill cycle if the underlying mechanical problem has not been corrected. Resetting is useful for confirming a repair was successful, but it is not a fix on its own. Address the root cause first, then reset to verify the code does not return.