Maytag Dishwasher Error Code F6-E2

F6-E2 on a Maytag dishwasher indicates an electrical problem in the fill valve circuit. The code can be caused by a loose wiring connection, an open fill valve solenoid coil, a blown fuse (F9) on the control board, or a failed drive circuit on the control board. The dishwasher flags this fault when it cannot properly energize the fill valve. Unplugging the unit and testing components with a multimeter is the recommended first step.

It is not recommended to continue running the dishwasher while F6-E2 is active. The fault indicates an electrical issue in the fill circuit, and the appliance may not fill correctly or may stop mid-cycle. Running it in this condition risks incomplete cleaning cycles and could potentially cause further electrical damage. The dishwasher should be unplugged until the fault is diagnosed and repaired.

Repair costs vary depending on the failed component. A replacement fill valve typically runs in the range of $30 to $80 for the part. A control board replacement is more expensive, generally ranging from $100 to $250 or more for the part alone. If a technician is needed, add labor costs on top of parts. Checking and reseating a loose connection costs nothing beyond your time.

A knowledgeable DIYer can address some causes of F6-E2 without professional help. After unplugging the dishwasher, checking and reseating wiring connections in the fill circuit costs nothing and should be done first. Testing the fill valve solenoid and fuse F9 with a multimeter is also straightforward. If the control board drive circuit has failed, replacement is more involved and may be better left to a technician.

Resetting the dishwasher may temporarily clear the F6-E2 code, but it will return if the underlying electrical fault is not corrected. The code is triggered by a measurable circuit fault, not a software glitch, so a reset alone does not address the root cause. The fill valve circuit, solenoid, wiring, and fuse F9 all need to be inspected and tested for a lasting repair.