Maytag Washer Error Code d5 (washer)

The d5 code on a Maytag washer indicates a Coin 1 sensor error, meaning the coin sensor has been detected as blocked for 8 continuous seconds. This applies to coin-operated washer configurations where the coin acceptor controls cycle access. The washer halts operation and displays this code to alert you that the sensor cannot clear its blocked state. A physical obstruction in the coin slot is the most common cause.

Resetting the washer will clear the d5 code from the display, but the code will return if the underlying blockage or sensor fault has not been corrected. Clearing the code is listed as the first diagnostic step, followed immediately by cleaning the sensor. A reset without addressing the physical cause is only a temporary measure and the code will reappear within seconds if the sensor remains blocked.

If the issue is simply debris in the coin sensor, the repair costs nothing beyond your time to clean it. If the Coin 1 sensor itself needs replacement, parts and labor typically range from around $75 to $200 depending on your location and service rates. Control board replacement, if required as a last resort, can range from $200 to $400 or more including labor.

Start by clearing the error code, then unplug the washer from power before doing any inspection. Physically examine and clean the Coin 1 sensor and the entire coin acceptor channel, removing any stuck coins, debris, or buildup you find. After cleaning, restore power and test the washer to see if the code returns. If it does, the sensor or its wiring may need further diagnosis or replacement.

The d5 error typically prevents the washer from completing a normal cycle since the coin sensor must register correctly before operation proceeds in coin-operated units. Attempting to force a cycle without resolving the sensor issue is not recommended, as it could mask a wiring or component problem. The safest approach is to resolve the sensor fault before resuming use.