Maytag Washer Error Code E102

E102 means the washer's built-in weighing system detected a load weight that is much higher than the normal expected range. This code only appears on Maytag models equipped with a load cell weighing system. It can be caused by an actual overload in the drum, a wiring fault in the load cell circuit, or a failing load cell sensor. The washer stops the cycle to prevent mechanical damage from what it perceives as excessive weight.

You should not continue running the washer while E102 is active. The machine has stopped the cycle because it detected an abnormal weight condition, and forcing it to continue could place excessive stress on the drum bearings, suspension, and drive components. Resolve the underlying cause before resuming normal use.

A reset may temporarily clear the E102 code, but if the underlying problem is still present, the code will return as soon as the washer attempts to weigh the load again. Clearing the code without fixing the root cause is not a lasting solution. Address the load cell wiring, the load cell itself, or the actual overload condition before relying on a reset.

In some cases, yes. Start by reducing the load size and restarting the cycle to rule out an actual overload. If the error persists with a normal load, you can inspect the load cell wiring harness for visible damage or loose connectors, which is a straightforward task for a confident DIYer. Replacing the load cell itself requires some disassembly and is more involved, but is manageable with basic mechanical skill.

If the issue is simply an overloaded drum, there is no repair cost. Wiring repairs or connector cleaning are low-cost fixes, typically in the range of $0 to $50 in parts. A load cell replacement generally costs between $30 and $100 for the part, plus labor if a technician is hired. A main control board, if needed, can range from $100 to $300 or more depending on the model.