Maytag Washer Error Code E353

E353 means the frequency inverter, the board that controls motor speed, has detected an internal circuit failure within itself. The inverter ran a self-diagnostic check and determined the fault is inside the board rather than from an external sensor or wiring issue. This error code requires the inverter board to be replaced to restore normal washer operation.

A power reset may temporarily clear the error display, but E353 reflects an internal hardware fault confirmed by the inverter's own self-diagnostic routine. Because the fault is inside the board, it will return once the washer attempts to operate again. A reset is not a repair and should not be relied upon as a solution.

The cost to repair E353 typically includes the price of the replacement frequency inverter board plus labor. Parts alone can range from roughly $80 to $250 or more depending on the model, and professional labor charges vary by region, often adding $100 to $200 to the total. Getting a quote from a local appliance repair technician before committing to the repair is advisable.

Replacing the frequency inverter is the prescribed repair for E353, and this task involves working near high-voltage components inside the washer. Most homeowners should have a qualified appliance technician perform this repair. Technicians comfortable with appliance electronics can replace the inverter board, but the work should only be done with the washer fully unplugged from power.

No, you should not continue operating the washer while E353 is active. An inverter with an internal circuit failure cannot reliably control the drive motor, which could result in unpredictable motor behavior or further damage to connected components. Disconnect the washer from power until the inverter is replaced.