Maytag Washer Error Code E600

E600 on a Maytag washer indicates an internal software error that should not occur under normal operating conditions. It is not a standard component fault like a sensor or motor failure. Because it reflects an abnormal software state within the control board, the first recommended step is to contact Maytag directly for guidance.

It is not recommended to continue operating the washer while E600 is active. Because the error reflects an unexpected internal software state, the machine's behavior during a cycle may be unpredictable. Stop using the appliance and contact Maytag support before running additional loads.

Repair costs for E600 will depend on the root cause identified after Maytag is consulted. If a control board replacement is required, parts and labor typically range from $150 to $400 depending on the model and service provider. If the issue can be resolved through a firmware update or software reset performed by a technician, costs would generally be lower, covering only the service call fee.

Standard DIY repairs are not well-suited for the E600 error because it is a software-level fault rather than a straightforward component failure. Maytag specifically recommends notifying them when this code appears. A Maytag-authorized technician with access to current service bulletins and potential firmware update tools is the appropriate resource for resolving this code.

Power cycling the washer may temporarily clear the E600 code from the display, but it is unlikely to resolve the underlying software fault permanently. The error may return, especially if the control board has sustained damage or if a firmware issue is present. A reset alone should not be considered a fix for this code.