Maytag Washer Error Code F05 E02

F05 E02 means the washer's control board attempted to lock the door but did not receive confirmation that the lock engaged successfully. The washer stops as a safety precaution and will not run with an unconfirmed door lock. The issue can stem from an obstruction, a faulty latch, a failed door lock assembly, or a wiring problem.

Pressing POWER cancels the active cycle and clears the displayed error, but the code will return if the underlying cause is not resolved. If the door is fully closing and latching without obstruction, a simple reset may allow the cycle to complete. However, if the lock assembly or wiring is faulty, the error will reappear at the start of the next cycle.

If the fix is simply clearing an obstruction or reseating a loose wiring connector, there is no parts cost. A replacement door lock assembly typically costs between $30 and $80 for the part alone, depending on the specific model. If professional repair is needed, expect total costs in the range of $100 to $250 including labor, though a failed control board would push costs higher.

Start by pressing POWER to cancel the cycle, then open the door and check for any clothing or items caught in the door opening or along the gasket. Close the door firmly and restart the cycle. If the error returns, inspect the door latch and strike for damage, check the wiring harness at the lock assembly, and consider replacing the door lock assembly if those components show wear or failure.

The washer is designed to halt operation when it cannot confirm the door is locked, so it will not run a spin or wash cycle while this error is active. You should not attempt to bypass the door lock, as an unlocked door during operation is a safety hazard. Address the root cause before resuming normal use.