Maytag Washer Error Code F4

F4 indicates a board failure in the level circuit, meaning the microprocessor board is inoperable. The level circuit is responsible for monitoring the water level inside the tub, and when the board fails in this area, the washer cannot function. The recommended repair is replacing the microprocessor board.

No, you should not attempt to run the washer while F4 is active. Because the microprocessor board is inoperable, the machine cannot properly control the wash cycle or monitor water levels, which could lead to overfilling or other unsafe conditions. Stop using the washer until the board has been replaced.

A power reset by unplugging the washer for a few minutes may temporarily clear the code, but if the microprocessor board has genuinely failed, the F4 error will return when the washer is powered back on. Resetting is a useful first diagnostic step, but it is not a solution to an inoperable board.

A knowledgeable DIYer can attempt this repair by locating and replacing the microprocessor board. Before ordering parts, check that all wiring harness connectors at the board are secure and free of corrosion. If connections are solid and the error returns after a power reset, the board itself needs to be replaced.

Repair costs depend on parts and labor. A replacement microprocessor board typically costs anywhere from $80 to $250 or more depending on the specific model. If you hire a technician, expect to add $75 to $150 in labor costs on top of the part price.