Wolf Range Error Code 07-15

Error code 07-15 means the control system has detected an open circuit in the broil relay. The broil relay is located inside the Relay Module and is responsible for switching power to the broil element. When the relay fails to close or a wiring connection is lost, the code is triggered and the broiler will not operate. A technician needs to inspect the wiring connections and likely replace the Relay Module.

With a 07-15 fault active, the broiler will not function, but the stovetop burners and oven bake functions may still operate normally depending on your model. The range is not typically a fire or shock hazard in this fault state, but operating appliances with active fault codes is not recommended. Have the issue diagnosed and repaired before relying on the appliance.

Power cycling the range may temporarily clear the fault display, but the code will return if the underlying problem with the broil relay circuit has not been corrected. The fault is tied to an actual circuit condition, not a software glitch, so a reset is not a fix. The wiring connections must be inspected and the Relay Module must be tested or replaced to permanently resolve the fault.

A knowledgeable DIYer can start by checking that all wiring harness connectors at the Relay Module and control board are fully seated and free of corrosion. However, if the Relay Module itself has failed, it must be replaced, which involves working with high-voltage components. Unless you are comfortable with appliance electrical repair and proper safety precautions, this repair is best handled by a qualified technician.

Repair costs depend on whether the fix requires only a connector correction or a full Relay Module replacement. A wiring or connector repair by a technician would generally fall in a lower labor-only cost range. If the Relay Module requires replacement, expect combined parts and labor costs in the range of several hundred dollars, reflecting both the Wolf component pricing and professional service time.