Wolf Range Error Code 07-24

Error code 07-24 indicates that the DLB2 relay, located on the relay module, has been detected in an open state. This relay is responsible for switching power to a heating element during baking or broiling. The control board flags this fault when it cannot confirm the relay is closing properly. The range may disable the affected heating function until the issue is resolved.

This fault involves a safety relay that controls power to a heating element, so continued use is not recommended until the issue is diagnosed. The range may already be preventing the affected cooking function from operating. Using the range while a relay fault is active could potentially lead to uncontrolled or absent heating, and the underlying cause should be addressed promptly.

Repair costs vary depending on whether the fix is a wiring correction or a full relay module replacement. Parts costs for relay modules on Wolf ranges typically fall in the range of $150 to $400 or more, depending on the specific model. Adding professional labor, total repair costs generally range from $250 to $600. Wolf appliances are high-end units, so obtaining service through an authorized technician is advisable.

A knowledgeable DIYer can start by checking that all wiring harness connectors at the relay module are firmly seated and show no signs of corrosion or burning. However, if the connections are intact, the relay module itself needs to be replaced, which involves working near high-voltage components. For safety, relay module replacement is best handled by a qualified appliance technician.

A power reset may temporarily clear the error display, but the fault will return if the underlying relay hardware issue has not been corrected. Error 07-24 points to a physical component failure, specifically an open relay, that cannot be resolved through a reset alone. The relay module connections and the module itself must be inspected and repaired.