mypros+
Error code reference

Wolf Range Error Code 07-35

RM Ambient Thermistor open error.

Avg. service call
$285
National average. Trip fee plus diagnostic plus labor. Before parts.
MyPros+ 3-day pass
$9.95
Same diagnostic steps, on your phone. Start now.
You keep in your pocket
~$275
Even before you buy the part.
Skip the service call. Fix it yourself.
Full procedure unlocks instantly.
Get Started

What the 07-35 error code actually means

Your Wolf range has detected a broken connection in the temperature sensor inside a component called the Relay Module. This sensor is responsible for monitoring heat levels inside that part to keep it running safely. The range flagged this problem because it can no longer get any reading from that sensor at all.

Diagnostic procedure

The full 07-35 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Check connections, replace Relay Module.
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock 07-35 procedure $9.95

Or subscribe: $29/month for unlimited access to all codes plus Max AI diagnostics.

Most common causes of 07-35

Ranked by how often they cause this code
  1. 1Loose or disconnected wiring harness
  2. 2Failed ambient thermistor
  3. 3Damaged wiring or broken wire
  4. 4Corroded connector terminals
  5. 5Faulty Relay Module

Most DIYers save hundreds by diagnosing before ordering parts.

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

Questions people ask about 07-35

What does 07-35 mean on a Wolf range?
Error code 07-35 indicates an open circuit condition in the ambient thermistor located within the Relay Module. This thermistor monitors the internal temperature of the Relay Module as a protective measure. An open error means the control board is receiving no signal from that sensor, which could be caused by a disconnected wire, a broken connector, or a failed thermistor or Relay Module.
Will resetting the range clear error code 07-35?
A power reset may temporarily clear the fault display, but the error will return if the underlying open circuit condition has not been repaired. Because this code indicates a hardware fault in the thermistor circuit rather than a software or transient issue, resetting alone is not a fix and the range may not operate normally until the problem is corrected.
How much does it cost to repair error code 07-35 on a Wolf range?
If the issue is simply a loose or corroded connector, repair costs may be limited to a service call fee, typically in the range of $75 to $150. If the Relay Module requires replacement, the total cost including parts and labor commonly falls between $300 and $600 or more depending on the specific model and local labor rates. Wolf is a premium appliance brand, so parts tend to be priced at the higher end of the market.
Can I fix error code 07-35 myself on a Wolf range?
A knowledgeable DIYer can begin by checking that all wiring connectors at the Relay Module are fully seated and free of corrosion, which requires no parts and may resolve the issue. However, if the wiring checks out and the fault persists, replacing the Relay Module is the required repair, and that work involves handling line-voltage components. For the module replacement step, many owners prefer to hire a qualified appliance technician.
Is it safe to use my Wolf range while error code 07-35 is active?
Operating the range with this fault active is not recommended. The ambient thermistor inside the Relay Module serves a protective function by monitoring internal operating temperatures. With that sensor circuit open, the Relay Module cannot detect its own overheating condition, which could allow the component to operate outside safe thermal limits. The range should be serviced before continued use.

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass