mypros+
Model reference

Caloric DCR-211-1L-OL

Dishwasher

36 error codes10 service modes
MyPros+ Max

Diagnose your Caloric DCR-211-1L-OL.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (36)

CodeMeaning
dLLid Lock FailuredULid Unlock FailureE2Overheating of the induction coil (display flashing).E5Error on filter board due to incorrect wiring or error on power board.E6Error on power unit due to incorrect wiring or error on power board.E9Coil temperature sensor defective.Er 20Flash failure; microcontroller (μC) is faulty.Er 22Permanent use of keypads; control unit cuts off after 10 seconds due to water…Er 31Configuration data incorrect; configuration of induction necessary.Er 36NTC value is not within its specification (value < 200 mV or > 4.9 V); control…Er 47Communication error between touch control (TC) and induction module; none or…F 1Pressure Signal Out-of-RangeF 2Keypad/User Interface FailureF 40ATC Thermistor Open/ShortF 41Motor RPS Thermistor Open/ShortF 42Heater in unknown stateF 43Heater is continuously ONF 44Heater cannot be turned ONF 50Motor StalledF 51Motor RPS FailureF 52Motor Stop FailureF 53Motor Control OvertempF 54Motor Control OvercurrentF 72Basket Re-engagement FailureF2Membrane switch (touch panel) failure.F3HHumidity sensor out of range.F6Microwave relay failure.HCHot, Cold ReversedLdLong DrainLFLong Fill
View all 36 error codes
lidOpen/Close LidoLOverloadedPoPump OutSdSuds DetectionU400Secondary voltage of the power unit too high (primary > 300 V); control unit…uLUnbalanced Load

Service modes (10)

  • Automatic Diagnostic Test Mode["Ensure washer is not currently running a cycle (in-progress screen should not be…
  • Child Lock["Ensure the microwave oven and Timer are off.","Touch and hold CANCEL for 5 seconds until 2 tones…
  • Console and Indicators Diagnostic Test Mode["Ensure washer is not currently running a cycle and LCD is on.","Press Power/Cancel button and…
  • Demo Mode["Microwave oven and Timer must be off.","Touch and hold Timer for 5 seconds until two tones sound…
  • Diagnostic Test Mode1
  • Manual Diagnostic Test Mode["Perform steps 1 and 2 of Activation of Automatic Diagnostic Test Mode (Sound and Display >…
  • Pressure Transducer Calibration["Enter Manual Diagnostic Test Mode.","From the Component Activation screen, select the 'Pressure'…
  • Saved Fault Codes["Enter Service Mode (Sound and Display > Service Mode > 5, 6, 5, 6 within 5 seconds >…
  • Touch Panel and Electronic Control Diagnostic Test["Press and hold CANCEL while opening the door.","While still holding the CANCEL button, unplug the…
  • Touch Panel and Electronic Control Self-Diagnostic Test["Press and hold CANCEL while opening the door.","While still holding the CANCEL button, unplug the…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Caloric dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax