mypros+
Model reference

Electrolux EFMG517SIW

Dryer

4 documents31 error codes3 service modes

Available documentation

Service Manual

  • Technical Service Manual Front Load Electric and Gas Dryers57 pg
    Covers this model

Service Flash

  • Heat Expansion Noise Between Rear Bulkhead and Heat Duct2 pg
    Covers this model

Tech Tip

  • Troubleshooting Steps For E53 Lux Care Gas Dryer1 pg
    Covers this model
  • Tech Tip LNTT1717 Dryer Loose Sound Pack1 pg
    Covers this model
MyPros+ Max

Diagnose your Electrolux EFMG517SIW.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (31)

CodeMeaning
E41Door opened at cycle start.E42Door lock or wiring or sensing circuit on main board failure.E51Drum motor relay errorE52Drum motor start sensing errorE53Drum motor centrifugal switch errorE54Drum motor sensing errorE61Heater relay errorE63Heater short errorE64Heater open errorE65Thermostat openE67Heater sensing errorE71NTC 1 (Outlet Control Thermistor) open, disconnected, or main board fault.E72NTC 1 (Outlet Control Thermistor) short or main board fault.E73NTC 2 (Inlet Control Thermistor) open, disconnected, or main board fault.E74NTC 2 (Inlet Control Thermistor) short or main board fault.E91User interface communication errorE92User interface protocol incongruence errorE93Machine configuration checksum errorE94Cycle configuration checksum errorE97Missing program on CTF errorE9CUser interface configuration checksum errorE9EUser interface touch sensor not workingEBDLine safe relay short circuit errorEBELine safe errorEBFLine safe sensing errorEF1Ventilation blocked errorEF6Safety reset errorEH1Power supply frequency out of configured range.EH2Power supply amplitude out of rangeEH3Power supply amplitude out of range
View all 31 error codes
EH4Line wiring error

Service modes (3)

  • demo["Press power key and look for console light up.","Turn the selector to the 7th position from the…
  • diagnostic["Press power to turn machine ON.","Set cycle to Normal.","Press the Start button.","Power OFF…
  • factory_default_reset["Switch ON the machine via Power button.","Wait for 10 seconds.","Simultaneously hold Dry Level +…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Electrolux dryer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax