Model reference

GE GSD4910X72AA

Name: GE GSD4910X72AA
Brand: GE

Dishwasher

3 documents23 error codes4 service modes

Available documentation

Service Manual

Use and Care Guide Dishwasher24 pg
Covers this model
GE Consumer Service Training Technician Manual GE Built-in Dishwashers Generation-II Value & Smart Models E4 and E5 Controls41 pg
Covers this model

Other

DD04 992 pg
Covers this model

MyPros+ Max

Diagnose your GE GSD4910X72AA.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·GE Dishwasher

C1 on my GE GSD4910X72AA

M+

Slow draining detected; pump-out time

From Service Manual 357681, p.13:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure drain pump winding resistance at connector J7. Expected: 12 to 16 ohms at room temperature.

3.Verify the board switches the pump at 120 VAC during the drain cycle.

Part WD19X23874

Drain pump assembly

Error codes (23)

CodeMeaning

C1Slow draining detected; pump-out time exceeds 100 seconds, indicating a partial…C2Drain is blocked; pump-out time exceeds 400 seconds and the dishwasher cannot…C3Drain feedback sensor is not functioning; dishwasher will continue cycle with a…C4Flood condition detected; water level in the dishwasher has exceeded the normal…C5Two consecutive pump-out times of less than 6 seconds detected, indicating no…C6Water temperature did not reach 120°F during the main wash cycle.C7Temperature sensor (thermistor) is open or shorted; heater will not operate…dE RESETDetergent cup has been accidentally latched; display shows when RESET pad is…DRY (flashing)Value models E4There is too much water in the dishwasher (flood/overfill condition on Smart…E5Not enough water is entering the dishwasher, or the drain pump is temporarily…E6Water temperature in the dishwasher did not reach the proper wash temperature…E7The temperature sensor in the dishwasher is not functioning properly…ERMembrane switch or its connection to the entry/display module is faulty.F0Failed turbidity sensor: LOW SIGNAL F1Failed turbidity sensor: HIGH SIGNAL F4Failed turbidity sensor: NO SIGNAL NORMAL (flashing)Value models F-1 test diagnostic PFElectrical power to the dishwasher has been interrupted but is now back on…PF RESETElectrical power to the dishwasher has been interrupted but is now back on.POTS/PANS (flashing)Value models F-1 test diagnostic RINSE (flashing)Value models WASH (flashing)Value models

Service modes (4)

Detergent Cup Reset (Smart Models)["Close and latch the door.","Touch the RESET pad three times within 3 seconds.","Display will show…
F-1 Test Cycle (Smart Models)["Close detergent cup and latch door.","Press NORMAL and DELAY START pads at the same time and hold…
F-1 Test Cycle (Value Models)["Close detergent cup and latch door.","Press START and DELAY START pads at the same time and hold…
X10 Speed Test (Value Models)["Press the selected cycle pad (e.g., Normal Wash) for 3 seconds; control will beep twice to…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass