Model reference

Maytag RJSO2701A

Name: Maytag RJSO2701A
Brand: Maytag

Oven

2 documents40 error codes6 service modes

Available documentation

Tech Sheet

Tech Sheet - 1602588411 pg
Covers this model

Bulletin

Technical Bulletin - Hinge and Receptacle Modification1 pg
Covers this model

MyPros+ Max

Diagnose your Maytag RJSO2701A.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Oven

1c1c on my Maytag RJSO2701A

M+

Shorted key detected on the control

From Tech Sheet W15895778, p.30:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (40)

CodeMeaning

1c1cShorted key detected on the control circuit board.1c2cKeyboard tail disconnected; keyboard loop improper value.1c31Cancel key circuit problem (upper cavity or single oven).1c32Cancel key circuit problem (lower cavity).1c4cPower micro communication failure; CRC invalid.1c5cVCC or ground open circuit detected when cook or clean is programmed.1c6cEEPROM error; no response from EEPROM.1c7cControl not calibrated; calibration value out of range.1c81Cook profile corrupted in EEPROM; CRC invalid.1c82Cook profile corrupted in EEPROM; CRC invalid.1c8cCook profile corrupted in EEPROM; CRC invalid.1d11Runaway temperature (650°F) with door unlocked in upper oven cavity.1d12Runaway temperature (650°F) with door unlocked in lower oven cavity.1d21Runaway temperature (950°F) with door locked in upper oven cavity.1d22Runaway temperature (950°F) with door locked in lower oven cavity.3d11Temperature sensor failure (open) in upper oven; sensor resistance greater than…3d12Temperature sensor failure (open) in lower oven; sensor resistance greater than…3d21Temperature sensor failure (short) in upper oven; sensor resistance less than 0…3d22Temperature sensor failure (short) in lower oven; sensor resistance less than 0…3d41Meat probe shorted in upper cavity; probe resistance less than 0 ohms.3d42Meat probe shorted in lower cavity; probe resistance less than 0 ohms.3d51Meat probe not calibrated; calibration value out of range.4d11Door switch position failure in upper oven; door switch not closed when door is…4d12Door switch position failure in lower oven; door switch not closed when door is…4d21No Reverse Airflow Fan rotation (no/low RPM) in upper oven.4d22No Reverse Airflow Fan rotation (no/low RPM) in lower oven.4d31Reverse Airflow Fan state error (on when supposed to be off) in upper oven.4d32Reverse Airflow Fan state error (on when supposed to be off) in lower oven.4d41High Reverse Airflow Fan rotation (high RPM) in upper oven.4d42High Reverse Airflow Fan rotation (high RPM) in lower oven.

View all 40 error codes

4d51Door switch circuit failure in upper oven; door switch not open or closed.4d52Door switch circuit failure in lower oven; door switch not open or closed.9d11Latch will not lock in upper oven; lock switch not closed.9d12Latch will not lock in lower oven; lock switch not closed.9d21Latch will not unlock in upper oven; unlock switch not closed.9d22Latch will not unlock in lower oven; unlock switch not closed.9d31Latch both locked and unlocked simultaneously in upper cavity; lock and unlock…9d32Latch both locked and unlocked simultaneously in lower cavity; lock and unlock…9d41Latch neither locked nor unlocked in upper cavity; neither lock nor unlock…9d42Latch neither locked nor unlocked in lower cavity; neither lock nor unlock…

Service modes (6)

Control Lockout["Press and hold BACK and SETUP pads for 5 seconds."]
Demo Mode["Press SETUP pad.","Press DOWN ARROW pad to scroll to DEMO pad.","Select DEMO to activate.","Press…
Diagnostic Code Display Mode["Enter Test Mode.","Press 'Last Fault' pad to display last error code and oven configuration."]
Diagnostic Code Display Mode (Last Fault)["Enter Test Mode.","Press Last Fault pad to display last error code and oven configuration…
Sabbath Mode["Press SETUP pad.","Press DOWN ARROW pad.","Press SABBATH pad to activate Sabbath mode.","Select…
Test Mode["Press SETUP pad.","Press DOWN ARROW pad three times until SERVICE is displayed.","Press SERVICE…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass