Model reference
Maytag PER1125ACW
Range
9 documents37 error codes35 service modes
Available documentation
Tech Sheet
- Tech Sheet - 16026486F (FR)9 pg
- Tech Sheet - 160264867 pg
- Cuisinière électrique autoportante — Informations techniques9 pg
- Electric Freestanding Range — Technical Information7 pg
Service Manual
- Service Manual - Freestanding Electric Range54 pg
- Freestanding Electric Range Service Manual54 pg
- Failure Codes and Wiring Diagrams for Maytag Heritage Gas & Electric Ranges124 pg
- FAILURE CODES AND WIRING DIAGRAMS for MAYTAG HERITAGE GAS & ELECTRIC RANGES124 pg
Bulletin
- Service Pointer - 8178740 (Oven Starts Before Desired Temperature is Selected)2 pg
MyPros+ Max
Diagnose your Maytag PER1125ACW.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (37)
CodeMeaning
1c1cShorted key detected; disables buzzer for the affected key.1c2cKeyboard tail disconnected or keyboard loop has improper value.1c31Cancel key circuit problem; detected when incorrect cancel key value is…1c32Cancel key circuit problem (cancel key improper value) on lower oven cavity.1c4cMicro-communication failure detected after 5 serial communication attempts.1c5cVoltage-to-current converter or ground fault; DC voltage/ground at test point…1c6cEEPROM error detected after 5 attempts during active cooking.1c7cControl not calibrated; calibration value out of limits.1c81Cook profile corrupted in EEPROM for upper/single oven cavity (CRC invalid).1c82Cook profile corrupted in EEPROM for lower oven cavity (CRC invalid).1c8cCooking program error detected after 5 attempts during active cooking.1d11Runaway oven temperature exceeding 650°F (343.3°C); oven temperature sensor…1d12Runaway temperature (650°F) detected with door unlocked on lower oven cavity.1d21Runaway temperature (950°F) detected with door locked on upper/single oven…1d22Runaway temperature (950°F) detected with door locked on lower oven cavity.3d11Oven temperature sensor open circuit detected within 5 seconds during active…3d12Temperature sensor failure (open) on lower oven cavity3d21Oven temperature sensor short circuit detected within 5 seconds during active…3d22Temperature sensor failure (short) on lower oven cavity3d41Meat probe shorted3d51Meat probe not calibrated4d11Door switch position failure4d12Door switch position failure4d21No Reverse Airflow Fan rotation (no/low RPM) on upper/single oven cavity.4d22No Reverse Airflow Fan rotation (no/low RPM) on lower oven cavity.4d31Reverse Airflow Fan state error4d32Reverse Airflow Fan state error4d41High Reverse Airflow Fan rotation (high RPM) on upper/single oven cavity.4d42High Reverse Airflow Fan rotation (high RPM) on lower oven cavity.4d51Door switch circuit failureView all 37 error codes
4d52Door switch circuit failure9d11Door latch will not lock on upper/single oven cavity9d12Door latch will not lock on lower oven cavity9d21Door latch will not unlock on upper/single oven cavity9d22Door latch will not unlock on lower oven cavity9d31Door latch both locked and unlocked simultaneously on upper/single oven9d32Door latch both locked and unlocked simultaneously on lower oven
Service modes (35)
- 12-Hour Shutoff DisableEnabled via Sabbath mode activation.
- 24 Hour Clock Toggle["Press and hold Cancel and Delay pads for 3 to 5 seconds.","Press More + or Less
- Child Lock Out["Press and hold Cancel and Cook & Hold pads for 3 to 5 seconds until beep sounds."]
- Clock Display Toggle (On/Off)["Press and hold Cancel and Clock pads for 3 to 5 seconds."]
- Diagnostic Code Display["Must be started within 60 seconds of powering up the control.","Press and hold More + pad within…
- Diagnostic Code Display ModeWithin 60 seconds of power-up, press and hold More + for 3 to 5 seconds.
- Diagnostic Code Display Mode (H1 Controls)Press and hold AUTOSET pad for 3 seconds at power-up.
- Diagnostic Code Display Mode (H3 Controls)Press and hold Upper Cancel and Timer for 3 to 5 seconds within 5 minutes of power up.
- Diagnostic Code Display Mode (NSC Controls)Press and hold the More + pad for 3 to 5 seconds when powering up the unit (within 60 seconds of…
- Factory Default Reset["Press and hold Cancel and Keep Warm pads for 3 to 5 seconds until beep sounds."]
- Faults Access (EOC III Controls)1
- Keypad LockPress and hold Cancel and Timer simultaneously for 3 to 5 seconds. Use More + or Less
- Keypad Lockout["Press and hold Cancel and Timer pads for 3 to 5 seconds.","Press More + or Less
- One Watt Standby ModePress and hold Cancel and Less
- One-Watt Standby Mode["Press and hold Cancel and Less
- One-Watt Standby Mode (NSC Controls)Press and hold Cancel and Less
- Oven Temperature Adjustment["Press Bake pad.","Enter 550 on the digit-pad.","Immediately press and hold Bake pad for 3 to 5…
- Oven Temperature CalibrationPress Bake. Enter 550 on the numeric keypad. Immediately press and hold Bake for 3 to 5 seconds…
- Quick Test Mode["Must be entered within the first 5 minutes after power-up.","Press and hold Cancel and Broil pads…
- Quick Test Mode (EOC III Controls)1
- Quick Test Mode (Factory Verification)Within 5 minutes of power-up, press and hold Cancel and Broil simultaneously for 3 seconds
- Quick Test Mode (H1 Controls - Convection Model)1
- Quick Test Mode (H1 Controls - Non-Convection Model)1
- Quick Test Mode (H2/H2.5 Controls)1
- Quick Test Mode (H3 Controls)1
- Quick Test Mode (M1/M2 Controls)1
- Quick Test Mode (NSC Non-Self Clean Controls)1
- Sabbath ModeActivate the desired cooking function first, then press and hold Clock for 3 to 5 seconds to…
- Service Mode (EOC III Controls)1
- Temperature Display (°C/°F toggle)Press and hold Cancel and Bake simultaneously for 3 to 5 seconds. Use More + or Less
- Temperature Display (°F/°C toggle)["Press and hold Cancel and Bake pads for 3 to 5 seconds.","Press More + or Less
- Temperature Display (°F/°C)Press and hold Cancel and Bake pads for 3 to 5 seconds. Press More + or Less
- Temperature Display (C/F Toggle)Press and hold Cancel and Bake simultaneously for 3 to 5 seconds. Use More + or Less
- Temperature Display Toggle (°F/°C)["Press and hold Cancel and Bake pads for 3 to 5 seconds.","Press More + or Less
- Test Mode (UH Controls)1
Full entry steps, exit procedures, and test sequences are available in Max.
Related Maytag range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass