mypros+
Model reference

Maytag HAV1200AWQ

Washer

18 documents14 error codes4 service modes

Available documentation

Service Manual

  • Top Load Washer Service Manual99 pg
    Covers this model
  • Top Load Washer Service Manual99 pg
    Covers this model

Service Flash

  • Vibration in Spin Cycle - Repair Tip3 pg
    Covers this model
  • Maytag TL Bulletin TDL 0086 B8 pg
    Covers this model
  • Technical Bulletin - ITDL-0009-S When to add Pump Sleeve to pump_ITDL-0009-S1 pg
    Covers this model
  • Technical Bulletin - ITDL-0031-B New water pump design1 pg
    Covers this model

Bulletin

  • Technical Bulletin - TDL-0026-B Tub to Pump Hose improvement1 pg
    Covers this model
  • Technical Bulletin - TDL-0013-B New sheet metal transmission cover1 pg
    Covers this model
  • Technical Bulletin - New sheet metal transmission cover1 pg
    Covers this model
  • Technical Bulletin - Wash Basket Leans to One Side4 pg
    Covers this model
  • Technical Bulletin - Wash basket leans to one side2 pg
    Covers this model
  • Technical Bulletin - TDL-0013.B1 pg
    Covers this model
  • Technical Bulletin - ITDL-0009-S When to add Pump Sleeve to pump1 pg
    Covers this model
  • Technical Bulletin - Transmission and Seal design change8 pg
    Covers this model
  • Maytag PAV Trans Bulletin TDL 0017B B8 pg
    Covers this model
  • Technical Bulletin - New Hub and Seal8 pg
    Covers this model

Other

  • TDL 0026 B1 pg
    Covers this model
  • ITDL 0014 B8 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag HAV1200AWQ.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (14)

CodeMeaning
0No code present.1Power failure detected.15Thermistor out of range.16Thermistor possible open.17Thermistor possible short.18Motor thermal protector opened more than 5 times during a cycle.19Motor thermal protector opened.21Fill time exceeded 18 minutes.22Fill time less than 2 seconds.24Incorrect rotary switch position seen.25Rotary Switch 1 left of encoder failed at startup.26Rotary Switch 2 left of encoder failed at startup.28Rotary Switch 3 left of encoder failed at startup.31Model ID Unknown, Default model of 31 used.

Service modes (4)

  • Console Switch Test1
  • Display/Clear Service Codes1
  • Service Cycle1. Enter Service Mode. 2. Set Cycle Selection Knob to 'Regular' and press knob. Steps: Press knob
  • Service Mode (Electronic Controls)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass