mypros+
Model reference

Maytag MAH3000

Washer

43 documents8 error codes11 service modes

Available documentation

Service Manual

  • Washer Service Manual157 pg
    Covers this model
  • Maytag Neptune Mah3000 Washer Service Manual63 pg
    Covers this model

Bulletin

  • Machine Control Board Revision5 pg
    Covers this model
  • Revised Cabinet Vibration Absorber1 pg
    Covers this model
  • New Pump1 pg
    Covers this model
  • Intermittent Leaks1 pg
    Covers this model
  • New Machine Control Board - HNP1062 pg
    Covers this model
  • Service Bulletin - TS573 (Bolt Torque Specifications)1 pg
    Covers this model
  • Dispenser Bezel - Improved1 pg
    Covers this model
  • Technical Bulletin - Squeaking Noise during machine operation if the washer is installed on a Riser1 pg
    Covers this model
  • Service Bulletin - TS564 (Resolving Odor Complaints)2 pg
    Covers this model
  • Laundry Revised Machine Control Board2 pg
    Covers this model
  • Resolving Odor Complaints2 pg
    Covers this model
  • Bleach and Fabric Softener Dispenser2 pg
    Covers this model
  • Belts Falling Off1 pg
    Covers this model
  • Air Dome Hose Clip Eliminated1 pg
    Covers this model
  • Service Bulletin - TS592 (Door Difficult To Open)1 pg
    Covers this model
  • Pressure Switch Revised1 pg
    Covers this model
  • Bolt Torque Specifications1 pg
    Covers this model
  • Service Bulletin - TS590 (New Boot Clamp Wire)1 pg
    Covers this model
  • Airdome Hose Retainer1 pg
    Covers this model
  • Capacitors Added to 4-Coil Water Valve1 pg
    Covers this model
  • Service Bulletin - TS576 (New Lower Front Weight Switch and Bracket)1 pg
    Covers this model
  • New Cabinet Assembly1 pg
    Covers this model
  • Color-Coded Inlet Hoses1 pg
    Covers this model
  • New Boot Clamp Wire1 pg
    Covers this model
  • Door Difficult To Open1 pg
    Covers this model
  • Water In Dispenser Cup1 pg
    Covers this model
  • Service Bulletin - TS561 (Belts Falling Off)1 pg
    Covers this model
  • Service Bulletin - TS572 (Vented Door Liner)1 pg
    Covers this model
  • Service Bulletin - TS557 (Belt Replacement)1 pg
    Covers this model
  • Service Bulletin - TS635 (New Machine Control Board - HNP106)2 pg
    Covers this model
  • Service Bulletin - TS602 (Corrugated Drain Hose)1 pg
    Covers this model
  • Door Boot Gasket - Revised1 pg
    Covers this model
  • New Lip Seal Assembly and Shaft Sleeve1 pg
    Covers this model
  • Stops in Mid-Cycle3 pg
    Covers this model

Service Flash

  • RT26141 Software enhancement5 pg
    Covers this model

Training

  • Spring and Cable Removal2 pg
    Covers this model

Job Aid

  • Maytag Services Training Bulletin - Neptune Washers - Spring and Cable Removal2 pg
    Covers this model

Other

  • maytag_neptune_front_load_washer_service_manual157 pg
    Covers this model
  • TS5392 pg
    Covers this model
  • TS5571 pg
    Covers this model
  • TS6031 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MAH3000.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (8)

CodeMeaning
FLDoor fails to lock after 11 attempts.LODoor fails to unlock after 11 attempts.LrLocked rotorndNo drainnFNo fillodDoor switch was not seen open since the last final spinPFPower failure/power down detected (LED washer).sdExcessive suds detected

Service modes (11)

  • Advertising Mode (LCD Washer)Press and hold the Favorites and Back keys for 3 seconds.
  • Advertising Mode (LED Washer)Press and hold the Heavy Soil and Cotton/Sturdy keys for 3 seconds.
  • Board Input Test (LED Washer)While in Service Mode, press the Hand Wash key.
  • Board Output Test (LED Washer)While in Service Mode, press the Rinse key.
  • Motor & Motor Control Test["Disconnect power to the machine.","Inspect the motor to motor control wire harness for integrity…
  • Motor Phase Test["Disconnect power to the machine.","Inspect the motor to motor control wire harness for integrity…
  • Quick Service Cycle (LED Washer)While in Service Mode, press the Delicates key.
  • Quick Spin Test (LED Washer)While in Service Mode, press the Spin key.
  • Service Mode (LCD Washer - MAH7500)Press and hold the Back and Help keys simultaneously for 5 seconds.
  • Service Mode (LED Washer - MAH5500B)Press and hold the Delicates and Heavy Soil keys simultaneously for 3 seconds.
  • Tachometer Circuit Diagnostics["Inspect the motor control wire harness for integrity of connections on both ends

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass