Maytag Washer Error Code nd

The nd code stands for No Drain. It means the washer attempted to drain the tub but the water level did not drop below the required low water level reset point within 15 minutes before a spin cycle could begin. The washer stops and displays nd to indicate a problem in the drain system. Common causes include a blocked drain hose, a clogged pump filter, or a failed drain pump.

You should not continue running wash cycles while the nd code is active. If the washer cannot drain, running additional cycles will leave standing water in the tub and can put strain on the pump motor. Address the drain issue first before resuming normal use to avoid potential water overflow or pump damage.

Repair costs vary depending on the cause. Clearing a clogged drain hose or pump filter is typically a low-cost or no-cost fix that a homeowner can do without parts. Replacing a failed drain pump generally runs between 80 and 200 dollars in parts and labor depending on the model and service rates in your area. A faulty pressure switch is usually less expensive, often in the 40 to 100 dollar range for parts and labor.

Start by checking the drain hose for kinks, clogs, or improper standpipe insertion depth. Next, access and clean the drain pump filter, removing any debris or foreign objects. If the hose and filter are clear, listen for the pump running during a drain attempt and test the pump motor for continuity if it is silent. A faulty pressure switch or a household plumbing clog should also be investigated if the pump appears to be functioning.

Performing a reset by unplugging the washer for a minute and restarting the cycle may temporarily clear the display, but the code will return if the underlying drain problem has not been resolved. The nd code is triggered by a timed drain failure, so the root cause must be corrected for the error to stay clear.