Model reference

Maytag MFS25

Washer

2 documents16 error codes3 service modes

Available documentation

Service Manual

MFS25 125PN Service Manual65 pg
Covers this model

Installation Guide

Installation Instructions for MAYTAG CONNECT 360 Gen2 PD Multiload MC5 Washers8 pg
Covers this model

MyPros+ Max

Diagnose your Maytag MFS25.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Washer

CLOSE DOOR PRESS START on my Maytag MFS25

M+

A wash cycle was selected and Start was

From Tech Sheet W14284500, p.32:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part W10810403

Door lock assembly

Error codes (16)

CodeMeaning

CLOSE DOOR PRESS STARTA wash cycle was selected and Start was pressed while the door is still open…DOOR FAILThe door safety system has failed during the wash cycle; all other machine…DRAIN FAILUREWater was not drained from the machine within the set time; drain valve stays…EEPROM FAILA storage location in the EEPROM memory does not function properly.FILL FAILWater level did not reach the programmed level within the microprocessor…HEAT FAILRegistered temperature did not reach the programmed target temperature within…NO PROCESSA non-programmed wash cycle was selected and the Start keypad was pressed.OUT OF BALANCEThe out-of-balance safety switch has tripped approximately eight times in a row…OVERLOAD FAULTMotor has become thermally overloaded or motor contactor is overloaded; all…PAUSEThe SIGNAL function has been programmed in a particular step requiring operator…PROCESS COMPLETE PLEASE WAITThe wash cycle has completed and the machine is finishing final operations.PROCESS MEMORY EXCEEDMemory capacity has been exceeded during programming of a wash cycle when…SERVICE DUEThe number of completed wash cycles has reached the target figure pre-set in…TOO HOTTemperature probe records temperature above 50°C (122°F) when the door may…TOO HOT CHECK HEATINGThe heating sensor recorded a temperature that is 2.5°C (25°F) higher than…WATER IN CAGEWater is still in the cage at the moment when the door may normally be opened…

Service modes (3)

InitializationWhen SELECT PROCESS -- appears on the display, enter code 70.
Machine Type EntryWhen display shows SELECT PROCESS --, enter code 52. Display shows ENTER MACHINE ___. Then enter…
Programming ModeWhen SELECT PROCESS -- appears on the display, enter code 89 to enter programming mode.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass