Maytag Washer Error Code d19

The d19 code means the washer attempted to unlock the door six times and was unable to confirm a successful unlock on any of those attempts. The control board monitors feedback from the door lock assembly and logs this fault when it never receives an unlocked status signal. The problem can be electrical, mechanical, or a combination of both within the door lock assembly.

Disconnecting power will clear the stored d19 code from the display, but the underlying fault will cause the code to return if the door lock issue has not been resolved. Clearing the code is a useful first diagnostic step, but it is not a fix on its own. The lock assembly and wiring should be inspected before assuming the problem is gone.

If the repair only requires correcting a loose or damaged wiring connection, cost may be limited to a service call fee, generally in the range of $75 to $150. If the door lock assembly needs replacement, parts typically cost between $30 and $90 depending on the model, with labor adding $100 to $200 if a technician is hired. Diagnosing the root cause first helps avoid replacing parts unnecessarily.

Start by clearing the error code, then unplug the washer from the wall to cut power completely. Use the manual door release procedure on page 14 to free the door, then inspect the door lock assembly and its wiring harness for visible damage. If the wiring is intact, the door lock assembly itself likely needs to be tested for continuity and replaced if it fails.

It is not recommended to run a wash cycle with an active d19 code. The door lock system is a safety interlock that prevents the washer from operating with an unsecured door. A door that cannot properly lock or unlock could open during a cycle, which poses a water damage and safety risk. Address the door lock fault before resuming use.