mypros+
Model reference

Maytag MVWB765FC2

Washer

5 documents35 error codes6 service modes

Available documentation

Tech Sheet

  • techsheet w10607408 revf48 pg
    Covers this model
  • FOR SERVICE TECHNICIAN'S USE ONLY - Tech Sheet48 pg
    Covers this model

Service Flash

  • Technical Service Pointer W11347319 - Clothes Caught in Agipeller3 pg
    Covers this model

Training

  • Technical Training Pointer - Suspension Rod Bushing Elimination6 pg
    Covers this model

Installation Guide

  • Installation Instructions16 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MVWB765FC2.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (35)

CodeMeaning
F0E2Oversuds condition detectedF0E3OverloadF0E4Spin limited by water temperatureF0E5Off balance load detected (also displayed as 'OFB').F1E1Main control fault detected (stops washer during Service Diagnostics…F1E2Fault of the motor control section of the main control (stops washer during…F2E1User interface detecting a button is continuously activated (stuck button).F2E3UI mismatchF2E4UI software errorF2E5UI software errorF3E1Pressure system faultF3E2Inlet water temperature faultF4E1Heater stuck onF4E2Heater not turning onF5E1Lid switch faultF5E2Lid lock will not lock or lid lock failureF5E3Lid lock will not unlockF5E4Lid not opened between cyclesF6E2Communication errorF6E3Communication errorF7E0Loss of powerF7E1Loss of power during spinF7E2Motor drive module over temperatureF7E3Motor drive module over current.F7E4Motor drive module over voltage.F7E5Shifter failureF7E6Motor circuit loss of phaseF7E7Motor start failureF7E8Motor stator over temperatureF7E9Locked rotor
View all 35 error codes
F8E1Long fillF8E3Overflow or flood conditionF8E6Water hazardF9E1Long drainF9E2Water ring detected, pump drive system problem

Service modes (6)

  • Key Activation & Encoder Test["First activate Service Diagnostic Mode.","Press and release the 1st button used to activate…
  • Load Size Calibration Cycle["First activate Service Diagnostic Mode, then enter Service Test Mode.","Select function number…
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all indicators off).","Select any three buttons…
  • Service Diagnostics Verification Cycle["First activate Service Diagnostic Mode, then enter Service Test Mode.","Use Soil…
  • Service Test Mode["First activate Service Diagnostic Mode.","Press and release the 2nd button used to activate…
  • Software Version Display["First activate Service Diagnostic Mode.","Press and hold the 2nd button used to activate Service…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass