mypros+
Model reference

Maytag PAVT920AWW

Washer

18 documents14 error codes5 service modes

Available documentation

Service Manual

  • Washer Service Manual - Troubleshooting2 pg
    Covers this model
  • maytag-amana-top99 pg
    Covers this model
  • maytag-mav-1602650299 pg
    Covers this model
  • Top Load Washer Service Manual99 pg
    Covers this model
  • Maytag Performa Washer Service Manual114 pg
    Covers this model
  • Top Load Washer Service Manual99 pg
    Covers this model
  • Top Load Washer Service Manual99 pg
    Covers this model

Bulletin

  • Technical Bulletin - No agitation with lid open1 pg
    Covers this model
  • Transmission Housing Change1 pg
    Covers this model
  • LAT3500 Facia Change1 pg
    Covers this model
  • Technical Bulletin - New Hub and Seal8 pg
    Covers this model
  • Technical Bulletin1 pg
    Covers this model

Service Flash

  • Technical Bulletin - ITDL-0031-B New water pump design1 pg
    Covers this model

Tech Tip

  • Instruction Sheet4 pg
    Covers this model
  • Instruction Sheet4 pg
    Covers this model

Job Aid

  • Instruction Sheet - Herrin/Atlantis Platform Triple Lip Seal and Bearing Kit16 pg
    Covers this model

Installation Guide

  • Installation Instructions8 pg
    Covers this model
  • Performance Series Automatic Washer Use & Care Guide64 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag PAVT920AWW.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (14)

CodeMeaning
0No code (no error stored).1Power failure detected.15Thermistor out of range.16Thermistor possible open.17Thermistor possible short.18Motor thermal protector opened more than 5 times during a cycle.19Motor thermal protector opened.21Fill time exceeded 18 minutes.22Fill time less than 2 seconds.24Incorrect rotary switch position seen.25Rotary Switch 1 left of encoder failed at startup.26Rotary Switch 2 left of encoder failed at startup.28Rotary Switch 3 left of encoder failed at startup.31Model ID Unknown, Default model of 31 used.

Service modes (5)

  • Console Switch Test1
  • Display/Clear Service Codes1
  • Service Cycle1. Enter Service Mode. 2. Set Cycle Selection Knob to 'Regular' and press knob. 3. Fill and Wash…
  • Service Mode1
  • Service Mode (Electronic Controls)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass