mypros+
Model reference

Maytag W11565084C

Washer

1 document24 error codes6 service modes

Available documentation

Service Manual

  • Technical Manual - Maytag Pet Pro System Top Load Washer49 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag W11565084C.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (24)

CodeMeaning
F0E2Oversuds condition detected; suds prevent the basket from spinning up to speed…F0E3Overload detected; main control detects a load size that exceeds the washer's…F0E4Spin limited by water temperature; water temperature is too high to spin at…F0E5Off balance load condition detected.F0E7Load detected when running Clean Washer cycle.F0E8Water ring fault; too much residual water is detected.F0E9Off balance pause; off balance condition detected after user interventions.F1E1Main control (ACU) fault.F2E1HMI stuck button; user interface is detecting that a button is continuously…F2E2HMI disconnected from the ACU.F3E2Pressure system fault; main control detects an out of range or absent pressure…F5E1Lid switch faultF5E3Lid lock will not unlock; excessive force on lid preventing lock bolt from…F5E4Lid not opened between cycles; user presses START after consecutive cycles…F6E1Communication error; HMI cannot hear ACU, communication between HMI and ACU has…F7E1Tachometer missing or wrong signal; ACU cannot read the speed or power from the…F7E3Basket engaged during wash; shifter is not disengaging the basket for wash.F7E4Basket re-engagement failure; shifter is not engaging the basket for spin.F7E6Motor circuit open; main control detects one or more of the motor lines is open.F7E7Motor unable to reach target RPM.F8E1Long fill; water level does not change for a period of time or water is present…F8E3Overflow or flood condition; main control senses water level that exceeds…F8E6Water hazard; main control senses water in the tub and the lid has been left…F9E1Drain pump system problem

Service modes (6)

  • Automatic Test Mode["Activate Service Diagnostic Mode first.","Press and release Key 2.","Press Key 5/Start to begin…
  • Factory Mode["Ensure washer is in standby mode (plugged in with all LEDs off) and lid is closed.","Within 8…
  • Fault Code Display["Activate Service Diagnostic Mode first.","Press and release Key 3 to display the most recent…
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all LEDs off).","Within 8 seconds, press and…
  • Software Version Display["Activate Service Diagnostic Mode first.","Press and hold Key 2 for 5 seconds.","Display will…
  • UI Test["Activate Service Diagnostic Mode first.","Press and release Key 1.","All LEDs flash once, then…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass