Maytag Washer Error Code F0E8

The F0E8 code on a Maytag washer signals a water ring fault, meaning the washer's control has detected too much residual water in the tub. This typically points to a drainage problem such as a clogged filter, blocked hose, or failing pump. The first step is to run a Drain and Spin cycle to see if the washer can clear the water and reset the condition.

You should not run a full wash cycle while the F0E8 error is active, as residual water in the tub can indicate a drainage failure that could worsen or cause water spillage. Running a Drain and Spin cycle to clear the water first is the safe approach before attempting further loads. Once drainage is confirmed to be working correctly, normal use can resume.

Repair costs vary depending on the cause. Cleaning a clogged drain filter or clearing a hose blockage is a no-cost or very low-cost fix you can do yourself. If the drain pump needs replacement, parts and labor typically run anywhere from $150 to $350 depending on your location and service provider. A faulty pressure switch is generally a less expensive repair, with parts in the $20 to $75 range plus labor if a technician is needed.

Start by running a Drain and Spin cycle to attempt to clear remaining water. Next, clean the drain pump filter and inspect the drain hose for kinks or blockages. If the problem persists, check the drain pump for proper operation and inspect the pressure switch and its connecting hose for damage or disconnection.

Resetting the washer by unplugging it for a minute or canceling the cycle may temporarily clear the code, but the fault will return if the underlying drainage issue is not resolved. A reset is not a fix on its own. Addressing the root cause, such as cleaning the filter or clearing a hose blockage, is necessary to prevent the code from coming back.