Maytag Washer Error Code F08 E01

F08 E01 is a water supply error indicating the washer did not receive adequate water during the fill cycle. The control board monitors fill progress and triggers this code when water volume does not reach the required level within the expected timeframe. The washer will lock the door and run a drain cycle for about 8 minutes before allowing you to clear the code. It is a protective fault, not a sign of permanent damage.

Pressing POWER once after the drain cycle completes will clear the code temporarily, but if the underlying water supply issue is not corrected, the error will return during the next fill cycle. Address the root cause first, such as opening faucets fully or cleaning clogged screens, before restarting a wash load.

If the fix is simply opening a faucet or clearing a clogged screen, there is no parts cost involved. If the water inlet valve has failed and needs replacement, parts typically range from $30 to $80 depending on the model, with professional labor adding $75 to $150 or more depending on your area. Diagnosing the exact cause before ordering parts is recommended to avoid unnecessary expense.

Start by letting the 8-minute drain cycle complete with the door locked, then press POWER once to clear the code. Check that both hot and cold faucets are fully open, inspect both inlet hoses for kinks, and remove the hoses to clean the mesh screens at the inlet valve ports. If the error returns after those checks, the inlet valve itself may need to be tested and replaced.

The washer is designed to stop and drain when this code is triggered, so it will not run a wash cycle without sufficient water. It is safe to allow the drain cycle to complete and then investigate the cause before running another cycle. Continuing to attempt washes without resolving the supply issue could stress the pump and motor over time.