Maytag Washer Error Code lid

The LID code on a Maytag washer indicates that the control has detected a problem with the lid position or the lid switch circuit. It appears when Start is pressed with the lid open, when two cycles run back-to-back without the lid being opened between them, or when the control cannot properly detect the lid switch opening and closing. The first step is to close the lid and try restarting the washer.

A basic reset may temporarily clear the code, but if the underlying cause is a faulty lid switch or wiring problem, the error will return on the next cycle. If the code appeared only because the lid was open when Start was pressed, closing the lid and restarting should resolve it without any additional steps.

The cost of a lid switch replacement part typically ranges from around $15 to $60 depending on the specific model. If a technician is hired to perform the repair, total costs including labor can range from roughly $80 to $200. Diagnosing and replacing the lid switch is a repair many experienced DIYers can complete with basic tools.

Start by making sure the lid is fully closed and press Start again. If the error returns, the diagnostic procedure calls for running TEST #8, which checks the lid switch circuit for faults. If the switch is determined to be defective, it will need to be replaced. Also inspect the wiring harness connected to the lid switch for any loose or damaged connections.

The lid switch is a safety device that prevents the washer from agitating or spinning with the lid open. If the switch is faulty and stuck in the closed position, the washer may attempt to run without properly confirming the lid is secure. It is best to avoid using the washer until the lid switch circuit has been diagnosed and any defective components have been replaced.