mypros+
Model reference

Maytag MTW6300TQ

Washer

3 documents32 error codes7 service modes

Available documentation

Service Manual

  • Service Manual - 8178642 - Bravos Automatic Washer84 pg
    Covers this model
  • Bravos™ Automatic Washer84 pg
    Covers this model
  • Technical Education Job Aid 8178642 ML-5 Model MTW6300TQ Automatic Washer84 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MTW6300TQ.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (32)

CodeMeaning
dLDoor lock failuredUDoor unlock failureF1Pressure signal out-of-rangeF2Keypad/User interface failureF30Long fill (saved code for LF).F32Long drain (saved code for Ld).F40ATC thermistor is detected to be open or shorted.F41Motor rotor position sensor (RPS) thermistor is detected to be open or shorted.F42Heater thermistor open or shorted (not used on this model).F50Motor stalledF51Motor RPS failure or lower harness problem.F52Motor stop failureF53Motor control overtemperatureF54Motor control overcurrentF68Pressure signal out-of-range (saved code for F1).F70Overloaded (saved code for oL)F71Suds detection (saved code for Sd)F72Basket re-engagement failureF80Door lock failure (saved code for dL).F81Open/close door lid (saved code for lid).F82Door lock failure (saved code variant for dL).F83Door unlock failure (saved code for dU).F84Door lock failure (saved code variant for dL).F85Door lock failure (saved code variant for dL).HCHot and cold inlet hoses are reversed.LdLong drainLFLong filllidLid openedoLOverloadedPoPump out
View all 32 error codes
SdSuds detectionuLUnbalanced load detected

Service modes (7)

  • Automatic Diagnostic Test1. Washer must be in standby mode (plugged in with all indicators off, or only Clean indicator on)…
  • Automatic Diagnostic Test Mode1
  • Console and Indicators Diagnostic Test1. Plug in washer or reconnect power. 2. From Standby (Off) Mode, press and release the following…
  • Console and Indicators Diagnostic Test Mode1. Plug in washer or reconnect power. 2. From Standby (Off) Mode, press and release the following…
  • Manual Diagnostic Test1
  • Manual Diagnostic Test Mode1
  • Pressure Transducer Calibration1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass