Maytag Washer Error Code F68

F68 indicates that the pressure signal from the water level sensing system is out of the expected range. The washer uses a pressure hose connected between the tub and the control board to monitor water levels. When that signal is missing or abnormal, the board throws this fault code and stops the cycle. On some display configurations this fault may appear as F then 1 rather than F68.

A reset may temporarily clear the displayed code, but F68 is saved as a fault code in the control board's memory, meaning it reflects a real signal problem rather than a random glitch. If the underlying cause, such as a loose or damaged pressure hose, is not addressed, the code will return as soon as the washer runs another cycle.

If the fix is simply reseating or replacing the pressure hose, the repair cost is minimal, typically in the range of a few dollars to around $20 to $40 for a replacement hose. If the machine or motor control board needs to be replaced, costs rise significantly, with parts and labor commonly ranging from $150 to $400 or more depending on the specific model and service rates in your area.

Start by locating the pressure hose that runs from the tub to the machine or motor control board. Check that it is securely connected at both ends, free of kinks, and not cracked or clogged. If the hose is in good condition and properly seated, the next step is to replace the machine or motor control board, as the pressure signal interpretation circuitry on the board has likely failed.

It is best to avoid running the washer until the fault is resolved. The pressure sensing system controls how much water enters the tub during a cycle. If that system is not functioning correctly, the washer could overfill or fail to fill properly, potentially causing water damage or leaving laundry improperly washed.