mypros+
Model reference

Maytag MTW6600TB0

Washer

17 documents32 error codes7 service modes

Available documentation

Tech Sheet

  • Diagnostic Guide - Tech Sheet W10092700 Rev B16 pg
    Covers this model

Service Manual

  • Technical Education Job Aid 8178643 ML-6 Bravos Automatic Washer with 6TH Sense Technology84 pg
    Covers this model
  • Bravos Automatic Washer With 6th Sense Technology84 pg
    Covers this model
  • Service Manual - Bravos Automatic Washer with 6th Sense Technology84 pg
    Covers this model

Service Flash

  • Clothing Tangling and Balling2 pg
    Covers this model
  • Service Pointer 8178742 - Cabrio and Bravos Washers Intermittent Water Leak4 pg
    Covers this model
  • F1 Error Code Service Pointer Cabrio Washer2 pg
    Covers this model
  • F1 Error Code Service Pointer - HE Top Load Washers2 pg
    Covers this model
  • Service Pointer - 8178767 (F1 Error Code)2 pg
    Covers this model
  • Service Pointer 8178742 Intermittent Water Leak4 pg
    Covers this model
  • Service Pointer - W10611623 - Drain Hose Installation6 pg
    Covers this model

Training

  • Training Pointer - Replacement Bearing Procedure for Top Load, Direct Drive Washers16 pg
    Covers this model

Job Aid

  • Instruction Sheet for Bearing Replacement Procedure12 pg
    Covers this model

Quick Reference

  • Quick Reference Manual6 pg
    Covers this model
  • Quick Reference Manual2 pg
    Covers this model

Other

  • Maytag Washer Bravos MTW6500 6600 with84 pg
    Covers this model
  • 81787671 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MTW6600TB0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (32)

CodeMeaning
dLDoor lock failuredUDoor unlock failureF1Pressure signal out-of-rangeF2Keypad/User interface failureF30Long fill (saved fault code designation for LF display code).F32Long drain (saved fault code designation for Ld display code).F40ATC thermistor open/shortF41Motor RPS thermistor open/shortF42Heater thermistor open/short (not used on these models).F50Motor stalledF51Motor RPS failureF52Motor stop failureF53Motor control overtempF54Motor control overcurrentF68Pressure signal out-of-range (saved fault code designation for F then 1…F70Overloaded (saved fault code designation for oL display code).F71Suds detection (saved fault code designation for Sd display code).F72Basket re-engagement failureF80Door lock failureF81Open/close door lidF82Door lock failureF83Door unlock failureF84Door lock failure.F85Door lock failure.HCHot and cold inlet hoses are reversed.LdLong drainLFLong filllidOpen/Close Door LidoLOverloadedPoPump out
View all 32 error codes
SdSuds detecteduLUnbalanced load detected

Service modes (7)

  • Automatic Diagnostic Test1
  • Automatic Diagnostic Test Mode["Ensure washer is in standby mode (plugged in with all indicators off, or with only the Clean…
  • Console and Indicators Diagnostic Test1. Plug in washer or reconnect power. 2. From Standby (Off) mode, press and release the following…
  • Console and Indicators Diagnostic Test Mode["Plug in washer or reconnect power.","From Standby (Off) Mode, press and release SOIL LEVEL, then…
  • Manual Diagnostic Test1
  • Manual Diagnostic Test Mode["Perform steps 1 and 2 of the Automatic Diagnostic Test Mode entry procedure.","During the…
  • Pressure Transducer Calibration["Unplug washer or disconnect power.","Access the machine/motor control assembly.","Check hose…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass