Maytag Washer Error Code Ld

The Ld code on a Maytag washer stands for a lid sense error stored by the control board. It means the board detected a problem with the signal from the lid sensing circuit, which monitors whether the lid is open or closed. When this code is active, all wash cycles and the customer display are disabled until the code is manually cleared through set-up mode. Power line interference or a faulty lid switch are the most common causes.

Start by entering the washer's set-up mode to manually clear the stored Ld diagnostic code. Once cleared, run a cycle to see if the error returns. If it does, inspect the lid switch and its wiring harness for damage, loose connections, or corrosion. Persistent errors may require replacing the lid switch or, less commonly, the main control board.

If the Ld code is caused by power line interference and clears without any parts replacement, the only cost may be a service call fee, typically in the range of $75 to $150 depending on your area. Replacing a lid switch generally costs between $20 and $80 for the part, plus labor if a technician performs the repair. Control board replacement is more expensive, with parts often ranging from $150 to $350 or more, making it important to fully diagnose the cause before ordering components.

Simply unplugging the washer and plugging it back in may not clear the Ld code, because it requires a manual clear through the washer's set-up mode. You will need to enter set-up mode on the control panel to view and clear the stored diagnostic code. If the code returns after clearing, a component issue such as a bad lid switch or wiring problem is likely causing the fault to be re-triggered.

When the Ld code is active, the washer automatically disables all cycles, so it will not operate until the code is cleared. This means you cannot accidentally run the machine in an unsafe condition while the fault is logged. However, you should address the underlying cause before returning the washer to regular use, particularly if the lid switch or its wiring is found to be faulty.