mypros+
Model reference

Maytag MTW6500TB

Washer

4 documents32 error codes7 service modes

Available documentation

Service Manual

  • Technical Education Job Aid 8178643 ML-6 Bravos Automatic Washer with 6TH Sense Technology84 pg
    Covers this model
  • Bravos Automatic Washer With 6th Sense Technology84 pg
    Covers this model
  • Service Manual - Bravos Automatic Washer with 6th Sense Technology84 pg
    Covers this model

Other

  • Maytag Washer Bravos MTW6500 6600 with84 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MTW6500TB.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (32)

CodeMeaning
dLDoor lock failuredUDoor unlock failureF1Pressure signal out-of-rangeF2Keypad/User interface failureF30Long fill (saved fault code designation for LF display code).F32Long drain (saved fault code designation for Ld display code).F40ATC thermistor open/shortF41Motor RPS thermistor open/shortF42Heater thermistor open/short (not used on these models).F50Motor stalledF51Motor RPS failureF52Motor stop failureF53Motor control overtempF54Motor control overcurrentF68Pressure signal out-of-range (saved fault code designation for F then 1…F70Overloaded (saved fault code designation for oL display code).F71Suds detection (saved fault code designation for Sd display code).F72Basket re-engagement failureF80Door lock failureF81Open/close door lidF82Door lock failureF83Door unlock failureF84Door lock failure.F85Door lock failure.HCHot and cold inlet hoses are reversed.LdLong drainLFLong filllidLid openedoLOverloadedPoPump out
View all 32 error codes
SdSuds detecteduLUnbalanced load detected

Service modes (7)

  • Automatic Diagnostic Test1
  • Automatic Diagnostic Test Mode["Ensure washer is in standby mode (plugged in with all indicators off, or with only the Clean…
  • Console and Indicators Diagnostic Test1. Plug in washer or reconnect power. 2. From Standby (Off) mode, press and release the following…
  • Console and Indicators Diagnostic Test Mode["Plug in washer or reconnect power.","From Standby (Off) Mode, press and release SOIL LEVEL, then…
  • Manual Diagnostic Test1
  • Manual Diagnostic Test Mode["Perform steps 1 and 2 of the Automatic Diagnostic Test Mode entry procedure.","During the…
  • Pressure Transducer Calibration["Unplug washer or disconnect power.","Access the machine/motor control assembly.","Check hose…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass