Maytag Washer Error Code FCE8

FCE8 means the washer's control board is not receiving a response from the Wi-Fi module, which is the component responsible for connecting the appliance to your home network. The fault can result from a loose wiring harness, a module firmware issue, or a failed Wi-Fi module. The washer's core washing functions are typically not affected by this error code.

No, FCE8 is not a safety-related fault. It indicates a communication issue with the Wi-Fi connectivity module only, and it does not affect the washer's water, motor, or heating systems. You can safely continue using the washer while you diagnose or arrange for repair of the Wi-Fi module issue.

If only the wiring harness needs reseating or replacement, repair costs are generally low, typically in the range of a service call fee plus a modest parts cost. If the Wi-Fi module itself needs to be replaced, parts and labor together could range from roughly 100 to 250 dollars depending on your location and service provider. If the UIC board is found to be the source of the fault, costs will be higher.

Start by unplugging the washer for one to two minutes and then restoring power to perform a soft reset of the Wi-Fi module. If the code returns, check the wiring harness connections between the Wi-Fi module and the UIC board for looseness, corrosion, or damage. If the harness is secure and undamaged, the Wi-Fi module itself may need to be replaced.

A power cycle reset may clear FCE8 if the root cause was a temporary firmware fault in the Wi-Fi module. Unplug the machine, wait one to two minutes, and plug it back in. If the error returns after the reset, there is likely a physical wiring or hardware issue that requires further diagnosis.