Maytag Washer Error Code FCE6

FCE6 means the washer failed to complete a download of its machine setup data to a connected USB stick. This is a service-level function used to export configuration information, including model and serial number data, from the control board. The failure can be caused by a bad USB stick or by missing or incorrect programming in the Help Mode Sub Menu. Normal washing functions are generally not affected by this code.

Yes, FCE6 is related to a service data transfer function and does not indicate a fault with the washer's core mechanical or electrical systems. The unit should remain safe to operate for normal laundry cycles. However, if you are in the middle of a service procedure, the issue should be resolved before completing that process.

If the fix is simply replacing the USB stick or correcting programming entries, the cost is minimal, typically just a service call fee ranging from $75 to $150. If the USB port or the machine control board needs to be replaced, parts and labor costs can range from $150 to $400 or more depending on parts availability and your location. Getting a diagnostic visit from a qualified technician is the best way to determine the actual repair cost.

Start by inspecting the USB stick for damage and ensuring it is fully seated in the port. Try a different USB device to rule out a faulty drive. Next, access the Help Mode Sub Menu and verify that the model and serial number information is correctly entered and matches the washer's nameplate. Correcting any programming errors and retrying the download will often clear the error.

A basic power reset is unlikely to permanently clear FCE6 because the underlying cause, either a problem with the USB stick or incorrect model and serial programming, must be addressed first. Once the root cause is corrected and a successful USB download is completed, the error condition should be resolved. Simply cycling power without fixing the cause will likely result in the code returning when the USB transfer is attempted again.