Maytag Washer Error Code LV

The LV code means the washer detected incoming AC voltage below 90 VAC for 8 continuous seconds. The control board monitors line voltage and shuts down the cycle to prevent damage when voltage drops too low. This is a power supply issue, not a fault with the washer's internal components. The machine is working correctly by alerting you to an unsafe electrical condition.

You should not continue running the washer while the LV code is active. Operating motors and electronics at voltages below their rated minimums can cause overheating, premature component failure, and in severe cases, fire risk from stressed wiring. Resolve the low-voltage condition at its source before resuming normal use.

If the problem is a loose outlet or a failing breaker, repair costs are typically in the range of $75 to $250 depending on whether you hire an electrician. Replacing a wall outlet is on the lower end, while tracing and repairing faulty wiring or replacing a breaker panel component costs more. If the issue is a utility brownout, there is no cost to the homeowner beyond the service call to your utility provider.

Start by checking the wall outlet voltage with a multimeter while the washer is running to confirm whether the voltage is actually dropping below 90 VAC. Inspect the outlet and breaker for loose connections or signs of heat damage. If the outlet and wiring check out, contact your utility provider to report low voltage at your address. Do not use an extension cord with the washer, and make sure the appliance is on a dedicated circuit.

Resetting the washer may clear the code temporarily, but the code will return if the underlying low-voltage condition persists. The washer monitors incoming voltage continuously, so unless the supply voltage is brought back above 90 VAC, the LV error will reappear within 8 seconds of dropping below that threshold again. Fix the electrical supply issue first before attempting a reset.