mypros+
Model reference

Caloric DCR-225-1L-OM

Dishwasher

26 error codes9 service modes
MyPros+ Max

Diagnose your Caloric DCR-225-1L-OM.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (26)

CodeMeaning
C1Blocked coin 1 or coin drop control circuit failure (coin recognition and price…C2Blocked coin 2 or coin drop control circuit failure (coin recognition and price…EdNot receiving communications from installed debit card reader in Enhanced…F1E1Indicates a CCU (Cycle Control Unit) problem.F2E1Indicates a stuck button (depressed for over 20 seconds) or UI mismatch; only…F3E1Exhaust thermistor is open; temperature drops below 18°F (>50k ohms).F3E2Exhaust thermistor has shorted; temperature above 250°F (<500 ohms).F3E3Inlet thermistor is open; temperature drops below 18°F (>245k ohms).F3E4Inlet thermistor is shorted; temperature above 391°F (<328 ohms).F3E5Inlet and exhaust thermistors are both open; will occur if P14 connector is not…F3E6Moisture sensor strip is open; only appears in service diagnostic mode.F3E7Moisture sensor strip has shorted; only appears in service diagnostic mode.F4E1No voltage detected at the heater relay; only appears in Diagnostic Test Mode.F4E3Restricted/low air flow detected that may affect dryer performance.F4E4Low L2 voltage (less than 50V) detected at the CCU.F6E1Communication error from UI to CCU; communication between CCU and UI has not…F6E2Communication error from CCU to UI; communication between CCU and UI has not…L2Low L2 voltage (less than 50V) detected at the CCU.LdWasher lid sense error on control board or due to power line interference…LFWater level detection error on control board or due to power line interference…LSMotor sense error detected on control board or due to power line interference.LVVoltage detected below 90 VAC for 8 seconds.PFPower failure occurred while the dryer was running.SdLast drain occurring during final spin was slow.SFLast fill was slow.tFWater temperature sense error when equipped with temperature sensing water…

Service modes (9)

  • Customer-Focused Dryness Level Adjustment1
  • diagnostic mode["Enter set-up mode first.","While in any of the set-up codes 1 through 6, anytime a diagnostic…
  • field diagnostic cycle["Enter diagnostic mode (entire display flashing).","Press the LOWER MIDDLE key pad to start the…
  • help mode["Enter set-up mode first.","Navigate to special pricing option mode (code 2.XX).","Press the LOWER…
  • Install Diagnostics1
  • Loads Test Mode1. Dryer must be in standby mode (plugged in with all indicators off). 2. Within 5 seconds: press…
  • Service Diagnostic Mode1. Dryer must be in standby mode (plugged in with all indicators off). 2. Select any three buttons…
  • set-up mode["PD Models
  • Software Version Display1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Caloric dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax